Oman acdc power module potting requirements(1)

The potting of the acdc power module is very important. This process not only involves the protection of the power module potting acdc power module (waterproof, moisture-proof, dust-proof, anti-corrosion, etc.), but also involves the protection of the power module. thermal design.

(3) Before the installation is completed and the power is turned on, the wiring on each terminal should be checked and checked again to ensure that the input and output, AC and DC, single-phase and multi-phase, positive and negative, voltage and current values are correct. Prevent the occurrence of reverse and wrong connections.
(4) For high-power power supplies, there are generally two or more "+" output terminals and "-" output terminals. In fact, they belong to the same output electrode, but for the convenience of user wiring, they are connected together internally.
(5) The module power supply is not allowed to work at full load for a long time. The utilization rate of linear power supply should be controlled within 60%; the utilization rate of switching power supply should be controlled within 80%, otherwise it may cause early artificial failure of module power supply.

Commonly used power module potting materials are divided into three categories: epoxy resin, polyurethane and silicone rubber

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad LED advertising screen power supply manufacturers also use this epoxy resin acdc LED advertising screen power supply module. However, due to stress problems, the failure rate of this LED advertising screen power supply is very high, and buyers are miserable.