Finland acdc power module potting requirements(2)

Epoxies cannot be used for stress-sensitive and module sealing due to their hardness and are basically eliminated by module power supplies. However, due to its low cost, this epoxy is still used in cost-sensitive micropower supplies. Some domestic bad Marine boost power supply manufacturers also use this epoxy resin acdc Marine boost power supply module. However, due to stress problems, the failure rate of this Marine boost power supply is very high, and buyers are miserable.

module combination
(1) Parallel expansion. Connecting the output terminals of the same module in parallel can enhance the output capability, but the output voltage of the parallel modules should be adjusted to be consistent to ensure relative current sharing and avoid unnecessary oscillations. For modules with large current output, the lead resistance can also be carefully designed to achieve the effect of current sharing. The number of modules connected in parallel in this way should not exceed 2. At the same time, if one of the module outputs is faulty, the entire system will not work properly. The parallel expansion connection circuit RL is the load.

At present, the most commonly used power module is the addition of silicone. This kind of silica gel is generally 1:1, which is easy to operate. When acdc potting power modules, attention should be paid to its thermal conductivity. However, the bonding ability is not very strong, and it can be improved with primer.

Polyurethane has been used in China for a period of time, but due to its high hardness, inconvenient maintenance, and the price reduction of silicone rubber, the cost performance of polyurethane is not high.